I just did the spring cleaning on my hot tub and filled it. Once the water level was good, I flipped the switch at the breaker. I can hear the control box click (relay/solenoids). I check the heater pump and it's running....great. I hit the clean cycle button and let it run. After a few minutes, I noticed it was still running. I walk over and push the clean cycle button again to turn it off...and it stays running. I hit the Jet button (thinking I hadn't pushed the clean cycle button originally), and it does nothing. I walk over to the breaker and flip the breaker in the off position....all is quiet. After a minute or so, I flip the breaker back on and the tub goes back into full speed! What's the problem with it this time? The control panel buttons aren't doing anything. Is it a stuck relay, or contactor? Every year it's something. Three seasons ago it was the heater pump, then the two years ago it was the thermostat, last year it was jet problem and now this season start up it's this.

Can someone help? It's a 97 Hotsprings Sovereign.

Jeff C.