 |
 |
|
 |
|
| Author |
Message |
|
analyzethis
|
Post subject: WIRING FROM DISCONNECT TO PLC L1 & L2  Posted: Wed Nov 02, 2005 9:54 pm |
Joined: Sun Oct 09, 2005 6:45 pm
Posts: 3
|
|
I recently upgraded my control system and would like to find out if it matters which line is connected to L1 & L2.
The loads are 240V pump and heater, 120V blower and ozonator. My main board is connected to a GFCI disconnect. The incoming lines from the disconnect are both black. If one of the lines was red then it should be connected to L2, according to the diagram that came with the control.
Does it matter which post they connect to (considering only post marked L1 & L2)?
|
|
 |
|
 |
|
charger_1
|
Post subject: Posted: Mon Nov 07, 2005 4:40 am |
Joined: Fri Sep 03, 2004 12:27 am
Posts: 1153
Location: Albert Lea, MN
|
|
As long as it's 240V, no, it won't matter.
_________________
Please be patient for replies
ATTENTION! USE THE ADVISE ON THIS FORUM WISELY! WE ARE NOT LIABLE FOR INJURIES, DEATH, DAMAGE, ETC. ARISING FROM THE USE OF THE INFORMATION IN THIS FORUM!
NOTE: I can't guarentee knowledge of all spas.
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
