When I turn the tub on the pump runs on high speed only and does'nt shut off. Anyone have help??
chaiSTi
Post subject: Re: pump runs on high speed only
Posted: Thu Jun 11, 2009 12:01 pm
Joined: Thu Apr 30, 2009 5:34 pm Posts: 8
The high speed relay is probably stuck. If the relays are exposed, you could unstick. If the relays are in enclosed, the case can be pulled off to look at. This problem may come back though which requires that the relay be replaced or a new controller be ordered.
Denny
Post subject: Re: pump runs on high speed only
Posted: Mon Jun 15, 2009 10:37 am
Joined: Sun Jun 14, 2009 9:44 pm Posts: 87 Location: Olympia, WA, USA
I just had an identical problem with my D1 Chairman. One of the motors would only run on high, when on low it made a noise but did not turn. I removed the motor and took the end off it. I suspected the ballast was bad but it was ok. I did find the little weighted spring loaded centrifugal force gizmo that is attached to the motor shaft had come loose. I reattached it using some loctite and everything now works fine. First thing I would do is check to see if the motor is getting power when on low.
_________________ Denny Owner and general repair person for 2000 Dimension 1 Chairman Learning as I go.
samlee
Post subject: Re: pump runs on high speed only
Posted: Sat Jun 20, 2009 3:50 am
Joined: Thu May 21, 2009 5:27 am Posts: 2
chaiSTi wrote:
The high speed relay is probably stuck. If the relays are exposed, you could unstick. If the relays are in enclosed, the case can be pulled off to look at. This problem may come back though which requires that the relay be replaced or a new controller be ordered.
Users browsing this forum: No registered users and 0 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
