 |
 |
|
 |
|
| Author |
Message |
|
jroyal
|
Post subject: Where does this go?  Posted: Mon Apr 14, 2008 3:24 pm |
Joined: Fri Apr 11, 2008 1:53 pm
Posts: 3
|
|
Where does the temp sensor on the topside control mount to? I would assume somewhere in the plumbing, but where is the best location? I have a Sunset Spa. I think it might go where the inlet comes in from the bottom of the spa but I'm not quite sure. Thanks alot!
| Attachments: |
spp-CC4-240-10-I-00.jpg [ 86.36 KB | Viewed 417 times ]
|
|
|
 |
|
 |
|
Swine
|
Post subject: Re: Where does this go? Posted: Mon Apr 14, 2008 4:00 pm |
Joined: Sun Apr 03, 2005 12:50 am
Posts: 954
Location: SW Florida
|
|
Usually into a drywell.
A hollowed out fitting somewhere in the plumbing, where it can ascertain the water temp, without actually getting wet.
_________________
t'was a woman that drove me to drink, and I've never had the courtesy to thank her
|
|
|
|
|
|
|
Dr. Spa
|
Post subject: Re: Where does this go? Posted: Mon Apr 14, 2008 5:07 pm |
Joined: Tue Feb 24, 2004 9:20 pm
Posts: 310
Location: near San Francisco
|
|
Frequently the drywell is located in the stainless steel tube which houses the heating element. There may also be a clamp on top of the stainless steel tube for holding the temp sensor.
_________________
Dr. Spa™
Manufacturer of traditional wooden hot tubs,
and the finest insulating spa covers.
Roberts Hot Tubs
1-800-735-5290
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
