We've had some bad storms recently and now my display is scrambled (flashing lines all over the place at high rate of speed). I've cycled the power without success. All the pumps and blowers run and the temperature seems to run above my setting.

I've pulled both the spaside control panel (Morgan/Brett Aqualine 24-4811) and the control board (Brett Aqualine 34-5025 BL46) and there's nothing obvious like burnt tracks, odor, etc.

I suspect by the symptoms that it is one of these (I unplugged motors/blowers, etc with power off and still have the same symptoms when powered back on).

Is there one of these components that is more likely the culprit for such symptoms?

Randy

you did a decent job troubleshooting, perhaps a little too far regarding disconnecting everything....but you just wanted to rule them out.... I would suspect the circuit board at this point.