I have a gecko sspa-1 2 days ago went outside toget in and breaker was popped went to reset doesn't reset. I started to check beaker its fine so I checked fuse in pack and they are good. I unhooked heater leads and heater it fine,unplugged pump and blower theyare fine. I took meter tested terminal strip and had continuity from red to neutral and ground good went from black to neutral it beeped and also toground I got a beep does thi mean my transformer is bad or what. or how would I check out the rest of the board and transformer to see whats the problem
Thanks Mike

Did you ever figure out what was wrong with your spa? I have a sspa also and am experiencing the same thing as you described.

you'll need to isolate the fault - almost always the heater, but can also be a pump, blower, ozone attached to the pack - even a dead mouse shorting out the terminals in the pack!
try unplugging everything except your circulation pump or pump 1 if no circ pump - this will isolate to pump or heater. if pump is OK it usually runs a few seconds until heater relay clicks in - if power trips out - likely heater short, if all runs it will be faulty pump 2, blower, ozone - test one at a time until isolated