It is currently Thu Nov 20, 2008 12:27 pm

View unanswered posts | View active topics


Board index » Troubleshooting Your Hot Tub » Spa/Hot Tub Flo / Flow errors and solutions

All times are UTC - 5 hours



Login
Register  •  Username:   Password:   Log me on automatically each visit  



Write comments
  Page 1 of 1 [ 2 posts ] 
Author Message
Bob21262
 Post subject: Pressure switch Problem
PostPosted: Sat Aug 06, 2005 5:59 pm 

Joined: Sat Aug 06, 2005 5:51 pm
Posts: 1
We own a Jacuzzi Echo 140. Recently the seal went out of one of our two pumps. I replaced that and after a refill the next morning the display read FL. Owners manual says its the pressure switch. So I replaced that. Started up again and it still reads FL. Low pump works fine but high pump will not kick on.

Any ideas ?
Thanks
Bob
Offline
 Profile  
 
charger_1
 Post subject:
PostPosted: Mon Aug 08, 2005 2:44 am 

Joined: Fri Sep 03, 2004 12:27 am
Posts: 1153
Location: Albert Lea, MN
Double and tripple check your wiring. It is possible that during your seal replacement, you may have dislodged one or more wires.



_________________
Please be patient for replies

ATTENTION! USE THE ADVISE ON THIS FORUM WISELY! WE ARE NOT LIABLE FOR INJURIES, DEATH, DAMAGE, ETC. ARISING FROM THE USE OF THE INFORMATION IN THIS FORUM!

NOTE: I can't guarentee knowledge of all spas.
Offline
 Profile E-mail  
 
Display posts from previous:  Sort by  
Write comments
  Page 1 of 1 [ 2 posts ] 

Board index » Troubleshooting Your Hot Tub » Spa/Hot Tub Flo / Flow errors and solutions

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
AeroBlue: John Olson
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group