My hot tub is a blue ridge spa it has a gatsby circuit board and I can not get the thing to stop overheating no matter what I set the temp to it just goes up to the highest point and then it shuts itself down. Have new senors and new heater..
Attachments:
002.JPG [ 143.44 KB | Viewed 222 times ]
mattie187
Post subject: Re: circuit board help
Posted: Thu May 21, 2009 11:54 am
Joined: Wed May 13, 2009 5:20 pm Posts: 10
Does this have a burnt spot on it
Peteyboy
Post subject: Re: circuit board help
Posted: Thu May 21, 2009 2:06 pm
Joined: Sat Nov 15, 2008 4:11 pm Posts: 420
I'm not familiar with that spa but I would guess a stuck relay on the circuit board or a bad temp sensor (thermostat).
Pete
_________________ spas are electrical devices and can be dangerous to repair - use this advice at your own risk
You could try to tap on it with the back of a screwdriver - I'm not sure which one it is. Some people will solder a new relay on the board or replace the board, which can be expensive.
Users browsing this forum: No registered users and 0 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
