 |
 |
|
 |
|
| Author |
Message |
|
Steve Flanagan
|
Post subject: Re: Plumbing Diagram  Posted: Tue Sep 08, 2009 7:35 am |
Joined: Tue Sep 08, 2009 7:30 am
Posts: 3
|
|
I have a 1999 Hot Springs Sovereign with a leak under the moto-massage seat.
Is there any way to remove the side panels so you can replace them or is digging
out the bottom the only way??
I would like to get a plumbing diagram before I start digging.
Thanks in advance.
|
|
 |
|
 |
|
Tubman1
|
Post subject: Re: Plumbing Diagram Posted: Mon Nov 02, 2009 10:59 am |
Joined: Mon Nov 02, 2009 10:46 am
Posts: 3
|
Dan.the.spa.man wrote: I can send you one on Sunday, what is the problem? I have fixed tons of leaks on these. Hi Dan the spa Man, I you could please send me a diagram at verbeemp@novachem.com. I seem to have the same problem, a leak between the service panel and the Moto. I have check all of the conections at the Moto and all the foam is dry there. Still looking, but a diagram would help me alot. Thanks Tubman1
|
|
|
|
|
|
|
Tubman1
|
Post subject: Re: Plumbing Diagram Posted: Mon Nov 02, 2009 1:07 pm |
Joined: Mon Nov 02, 2009 10:46 am
Posts: 3
|
acmectec2001 wrote: I fixed a leak in the right side as your facing the spa. It was half way between the moto massage and the main panel. I am still getting water coming out from under the back, right in the middle. I tore the siding and dug some foam and its not the moto. I also dug in the center where the water is and its dry so im thinking its running from either the foot jet or the drain. The deck has a small amount of fall towards the end where I see the water. I cant get under the deck to pin point where it starts. It may be from one of the jets on the other side. I guess id have to tear off the siding to find that out. If you could send a diagram that would be great. My email is acmectec2001@hotmail.com. I have to figure out what to replace the foam and siding with now also. If I could email you my cell # and talk to you for a few minutes it would be very helpfull!!!! Thanks He Acmetec2001, It appears that I alos have a leak and by your description it is in the same area. Was it the drain area? Where did you dig to find the problem? I have checked around the Moto and it is all dry there. The water is following the center wooden 2x4 on the underside. I have the tub on it's side and am diging on both side of the wood to see where the foam will start to get wet, but have not found it yet. Any help would be great. Thanks Tubman1
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
