I have a 1995 Cal Spa. I checked it last Thursday and it was drained of water. I fixed the leak and refilled it. The jets and heater are not working. The shaft in the pump motor is turning. I bleed the air from the filter and the pipe near the pump. Any ideas on what I can do next? thanks

I am very interested in this as well. I have a 93 model Cal Spa which I just drained and cleaned. I've had a challenge in the past getting it bled, but this time I can't get it to circulate. I've bled out 20-30 gallons of water to no avail.

Cal spas are one of the hardest spas to prime. When you do bleed the air out, the motor has to be off. I was doig a service call and it took about 15 minutes to get the pump circ. again.

My 95 Cal Spa gives me no priming problems only if I get the water
level at least half way up the skinner face. Don't know which model you have ( mine's a Kona ) but once I get that level up high, I just fire
it up and bleed the air like you do and BAM !!!!

Oh if you have a Main "diverter" jet like I do, I find that it kicks
butt even faster if I crank it around to blow only from itself....
nothing diverted to the other 10 jets.

Hopefully this makes sense.

Good luck and you could always call 1 800 CAL SPAS ( HeHeHe )