Hi,

I just emptied/refilled my tub today and the pH was a bit on the low side so I added pH Up (Sodium Carbonate I believe) and let it mix in with the jets on for a minute. I then added some stain/scale remover that I normally add on a regular basis (again with the jets on), and immediately the water went cloudy, even after turning off the jets.

I know the stain/scale remover bottle says "don't add on the same day as adding clarifier, or the water may become cloudy", but it doesn't say anything about adding it at the same time as pH Up. The only other chemical I added earlier today after the refill was dichlor.

Will this cloudiness clear up with the circ pump going or will I need to dump the water and start fresh?

Thanks,
-- Vinnie